[nmglug] Re:lost xserver upon upgrade is OK now, no network tho!
Brian O'Keefe
okeefe at cybermesa.com
Wed Apr 26 16:52:47 PDT 2006
OK, here's an update with the output of the same commands. At least the eth1
scan found an essid. I hadn't done anything different when I booted into
Linux but the scan found "home" nonetheless. Anyway here's the output:
$ iwlist scan
lo Interface doesn't support scanning.
eth0 Interface doesn't support scanning.
eth1 Scan completed :
Cell 01 - Address: 00:13:46:BF:5C:BE
ESSID:"home"
Mode:Master
Frequency=2.437 GHz (Channel 6)
Signal level:-67 dBm Noise level:-98 dBm
Encryption key:off
sit0 Interface doesn't support scanning.
brianokeefe at ubuntu:~$ iwconfig
lo no wireless extensions.
eth0 no wireless extensions.
eth1 IEEE 802.11b ESSID:"home" Nickname:"home"
Mode:Managed Frequency:2.437 GHz Access Point: 00:13:46:BF:5C:BE
Bit Rate:11 Mb/s Sensitivity:1/3
Retry limit:4 RTS thr:off Fragment thr:off
Power Management:off
Link Quality=24/92 Signal level=-75 dBm Noise level=-99 dBm
Rx invalid nwid:0 Rx invalid crypt:0 Rx invalid frag:0
Tx excessive retries:0 Invalid misc:0 Missed beacon:0
sit0 no wireless extensions.
brianokeefe at ubuntu:~$ ifconfig
eth1 Link encap:Ethernet HWaddr 00:30:65:25:8D:87
inet addr:192.168.0.100 Bcast:192.168.0.255 Mask:255.255.255.0
inet6 addr: fe80::230:65ff:fe25:8d87/64 Scope:Link
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:2183 errors:0 dropped:0 overruns:0 frame:0
TX packets:75 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:710354 (693.7 KiB) TX bytes:26532 (25.9 KiB)
Interrupt:57
lo Link encap:Local Loopback
inet addr:127.0.0.1 Mask:255.0.0.0
inet6 addr: ::1/128 Scope:Host
UP LOOPBACK RUNNING MTU:16436 Metric:1
RX packets:8 errors:0 dropped:0 overruns:0 frame:0
TX packets:8 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:0
RX bytes:400 (400.0 b) TX bytes:400 (400.0 b)
brianokeefe at ubuntu:~$ sudo iwconfig eth1 essid "home"
Password:
brianokeefe at ubuntu:~$ sudo dhclient eth1
Internet Systems Consortium DHCP Client V3.0.3
Copyright 2004-2005 Internet Systems Consortium.
All rights reserved.
For info, please visit http://www.isc.org/products/DHCP
Listening on LPF/eth1/00:30:65:25:8d:87
Sending on LPF/eth1/00:30:65:25:8d:87
Sending on Socket/fallback
DHCPREQUEST on eth1 to 255.255.255.255 port 67
DHCPACK from 192.168.0.1
bound to 192.168.0.100 -- renewal in 265871 seconds.
brianokeefe at ubuntu:~$ route -n
Kernel IP routing table
Destination Gateway Genmask Flags Metric Ref Use Iface
192.168.0.0 0.0.0.0 255.255.255.0 U 0 0 0 eth1
0.0.0.0 192.168.0.1 0.0.0.0 UG 0 0 0 eth1
Thanks for the response. I ran some commands from suggestions at Ubuntuforums
also as well as your suggestions. I'm not great at the command line but
here's the output. Any suggestions would be much appreciated. As a thought, I
had mac-on-linux installed but it got wiped during the apt-get upgrade. I was
having an issue with it when I rebooted into Linux from OS X in that I had to
start MOL and then quit it for my network in Ubuntu to come up. I have no
idea if this is some vestigal problem or not. Anyway, here are the outputs
(except for the last bit which is a pico file).
brianokeefe at ubuntu:~$ iwlist scan
lo Interface doesn't support scanning.
eth0 Interface doesn't support scanning.
eth1 Failed to read scan data : Resource temporarily unavailable
sit0 Interface doesn't support scanning.
brianokeefe at ubuntu:~$ iwconfig
lo no wireless extensions.
eth0 no wireless extensions.
eth1 IEEE 802.11b ESSID:"ssid" Nickname:"ssid"
Mode:Managed Frequency:2.437 GHz Access Point: 00:13:46:BF:5C:BE
Bit Rate:11 Mb/s Sensitivity:1/3
Retry limit:4 RTS thr:off Fragment thr:off
Power Management:off
Link Quality=48/92 Signal level=-52 dBm Noise level=-100 dBm
Rx invalid nwid:0 Rx invalid crypt:0 Rx invalid frag:0
Tx excessive retries:0 Invalid misc:0 Missed beacon:0
sit0 no wireless extensions.
brianokeefe at ubuntu:~$ ifconfig
eth1 Link encap:Ethernet HWaddr 00:30:65:25:8D:87
inet addr:192.168.0.100 Bcast:192.168.0.255 Mask:255.255.255.0
inet6 addr: fe80::230:65ff:fe25:8d87/64 Scope:Link
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:173 errors:0 dropped:0 overruns:0 frame:0
TX packets:15 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:56308 (54.9 KiB) TX bytes:4356 (4.2 KiB)
Interrupt:57
lo Link encap:Local Loopback
inet addr:127.0.0.1 Mask:255.0.0.0
inet6 addr: ::1/128 Scope:Host
UP LOOPBACK RUNNING MTU:16436 Metric:1
RX packets:4 errors:0 dropped:0 overruns:0 frame:0
TX packets:4 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:0
RX bytes:200 (200.0 b) TX bytes:200 (200.0 b)
brianokeefe at ubuntu:~$ sudo iwconfig eth1 essid ssid
Password:
brianokeefe at ubuntu:~$ sudo dhclient eth1
Internet Systems Consortium DHCP Client V3.0.3
Copyright 2004-2005 Internet Systems Consortium.
All rights reserved.
For info, please visit http://www.isc.org/products/DHCP
Listening on LPF/eth1/00:30:65:25:8d:87
Sending on LPF/eth1/00:30:65:25:8d:87
Sending on Socket/fallback
DHCPREQUEST on eth1 to 255.255.255.255 port 67
DHCPACK from 192.168.0.1
bound to 192.168.0.100 -- renewal in 268093 seconds.
brianokeefe at ubuntu:~$ route -n
Kernel IP routing table
Destination Gateway Genmask Flags Metric Ref Use Iface
192.168.0.0 0.0.0.0 255.255.255.0 U 0 0 0 eth1
0.0.0.0 192.168.0.1 0.0.0.0 UG 0 0 0 eth1
brianokeefe at ubuntu:~$ gedit /etc/resolv.conf
bash: gedit: command not found
brianokeefe at ubuntu:~$ pico /etc/resolv.conf
file has: 192.168.01
More information about the nmglug
mailing list